Description

DESCRIPTION
This specific pin allows you to lock any two 12mm materials together. Featuring a Countersink Bolt – allowing to sit flush on top side of your fixture, great for tight spots where a standard Locking Pin cannot be achieved.


Every hole surface on K16 Table Tops/Fixtures share 12mm of plate thickness.


Therefore this Ball-Lock Pin allows you to attach any one fixture to your table (toggle clamps/stops/angles/large angles/blocks). Or with creativity: any two fixtures together.

True meaning of modular!

MEASUREMENTS

DIRECTIONS
1. Place fixture in desired position.

2. Push pin in holes.

3. Twist top by hand to lock (an allan key or hex impact bit is used for a super tight lock).